Calibration Process - Mofi MasterDeck Manual

Calibration Process

Before calibrating your turntable it should be fully assembled
and leveled in its playing location with tonearm and power
supply brick attached.
1. Plug the AC cord into the power brick. When power is
CALIBRAT ION attached the MoFi Logo (light blue) is displayed for 1 second
2. Press the power button to start the platter. The button will
turn orange, the blue MoFi logo will turn on again for a few
seconds then calibration will begin. The display window will
read "CALIBRATION" in blue and show a spinning wheel for
3 3 .3
1 to 2 minutes while calibration is in process. When the
process is complete the turntable will power off and the
window and square button will not be lit. This full cycle only
®
happens the first time your MasterDeck is turned on after
being unplugged.