Kaba Group Saflok InSync M Installation Instructions

®
InSync M Installation Instructions
Installation Instructions
All parts needed to install the InSync
parts are accounted for before beginning installation. Do not substitute any of the parts. The use of
substitute parts will result in poor performance of the lock.
1. Prepare the door using the InSync M installation template.
2. Prepare the door frame using the template and install the strike
plate using the appropriate metal or wood screws (12 x 1-1/2) plate using the appropriate metal or wood screws (12 x 1-1/2)
provided. provided.
3. Install the mortise lock in the door mortise pocket while feeding 3. Install the mortise lock in the door mortise pocket while feeding
the motor wire through the notch on the inside of the door (see the motor wire through the notch on the inside of the door (see
Fig. 1). Fasten the mortise lock with the appropriate machine Fig. 1). Fasten the mortise lock with the appropriate machine
screws (12-24 x 3/8 flat head) or wood screws (12 x 1-1/4 flat screws (12-24 x 3/8 flat head) or wood screws (12 x 1-1/4 flat
head). Attach the lock face plate (scalp plate) using two head). Attach the lock face plate (scalp plate) using two
8-32 x 1/4 flat head machine screws. Make sure the dead bolt 8-32 x 1/4 flat head machine screws. Make sure the dead bolt
is retracted. If the dead bolt is projected, temporarily install the is retracted. If the dead bolt is projected, temporarily install the
inner trim and retract it. inner trim and retract it.
4. Verify the thumb turn spindle is oriented correctly 4. Verify the thumb turn spindle is oriented correctly
(see Fig. 2, Detail "A"). Place the outside trim in (see Fig. 2, Detail "A"). Place the outside trim in
position, CAREFULLY feeding the cables through the position, CAREFULLY feeding the cables through the
center 1/2" diameter hole (see Fig. 2). center 1/2" diameter hole (see Fig. 2).
Dead bolt
Deadbolt
cam slot
Cam Slot
Important:
If the thumb
turn spindle and dead bolt
cam are not properly oriented,
the lock will not work. See
Fig. 2, Detail "A."
All information contained herein, including but not limited to product pricing and other intellectual property, is confidential and All information contained herein, including but not limited to product pricing and other intellectual property, is confidential and
intended for the sole use of the addressee(s) so named. Any misuse of this confidential information contained herein may result in intended for the sole use of the addressee(s) so named. Any misuse of this confidential information contained herein may result in
legal action by Computerized Security Systems dba SAFLOK and its parent company. legal action by Computerized Security Systems dba SAFLOK and its parent company.
© SAFLOK™
InSync
®
M lock are included with each unit. Please check to make sure all
Thumb turn
Thumbturn
spindle
Spindle
Detail "A"
Step Four :
Step 4. Slots on dead bolt
Slots on deadbolt cam
cam must be horizontal.
must be horizontal
M
®
Step Four: Step 4. Feed the
cables through the
Feed cables
1/2" hole.
through 1/2" hole
Pg. 1 of 2
Fig. 1
Fig. 2
WL 6/3/2008