Dell Axim X30 Owner's Manual page 107

To start using LEAP, perform the following steps.
Obtain the following information from your network administrator:
1
• Network name
• Association mode
• Encryption method
From the Odyssey Client window, tap on Settings Configure Add.
2
Enter the network name (SSID) if known, or tap on Scan to search the
3
available Access Points. Tap Ok.
LEAP will only support an infrastructure network, so do not change the
4
default settings in the drop-down menu. Tap Next.
Fill in Association Mode and Encryption method. Tap Next.
5
EAP/TTLS is the preselected EAP type. Tap Add and select
6
EAP/LEAP in the window that opens up.
Unless you have an authentication certificate to use TTLS and have
7
configured your system to support it, remove EAP/TTLS. Tap Next.
NOTE:
prevent your wireless security system from functioning.
Enter user name and password. Tap Next.
8
Tap Finish to complete LEAP configuration.
9
Tap OK.
10
Select the network that you added from the drop down menu and tap
11
the box beside Connect to, leaving a check mark. Status will display as
connected (authenticated) when this process is complete.
NOTE:
For further details, please refer to the Odyssey Client help file included
in your device. You can access the help file at Start Help Odyssey Client for
Pocket PC.
Failure to remove EAP/TTLS when it is not properly set up may
Getting Connected
107