Advertisement
Quick Links
Installation Instruction:
Product: TVK-10
Car Model: 2010 Toyota Sequoia
Disclaimer:
We are not responsible to damage, loss or injury caused from attempting or performing the DIY.
Further, the
navigation and DVD
lock while in motion was originally installed for safety reasons. By
unlocking the navigation and DVD lock, we are assuming that the navigation and DVD will be controlled
and enjoyed by the passenger and not by the driver. As such, are not responsible to damage, loss or
injury from using the bypass modules. Please be responsible drivers!
1. REMOVE FRONT DOOR SCUFF PLATE RH
* Optional: You may skip step#1, if you can perform step#3 without removing the door scuff.
(a) Detach the 9 claws and remove the scuff plate.
2. REMOVE FRONT DOOR SCUFF PLATE LH
* Optional: You may skip step#2, if you can perform step#3 without removing the door scuff.
HINT: Use the same procedure for both sides.
Advertisement
Related Manuals for Beat-Sonic TVK-10
Summary of Contents for Beat-Sonic TVK-10
- Page 1 Installation Instruction: Product: TVK-10 Car Model: 2010 Toyota Sequoia Disclaimer: We are not responsible to damage, loss or injury caused from attempting or performing the DIY. Further, the navigation and DVD lock while in motion was originally installed for safety reasons. By unlocking the navigation and DVD lock, we are assuming that the navigation and DVD will be controlled and enjoyed by the passenger and not by the driver.
- Page 2 3. REMOVE INSTRUMENT SIDE PANEL LH (a) Using a molding remover, detach the 7 claws and remove the side panel. 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (a) Remove the 2 bolts. (b) Detach the 9 clips and claw. (c) Detach the 2 claws and remove the sensor.
- Page 3 5. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (a) Twist the shift lever knob in the direction indicated by the arrow and remove it. 6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (a) Detach the 12 clips and remove the console panel. 7. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY (a) Move the shift lever to N.
- Page 4 8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (a) Detach the 4 claws and remove the instrument panel finish panel retainer. (b) Disconnect the 2 connectors and detach the wire harness clamp. (c) Detach the 12 clips and remove the finish panel. 9.
- Page 5 10. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Detach the 4 clips and separate the panel. (b) Disconnect the connectors and remove the panel. 11. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (w/ USB Audio System) (a) Remove the 4 bolts. (b) Pull the navigation receiver as shown in the illustration to disengage the 3 clips on the backside of the navigation receiver.
- Page 6 15. Locate the GPS (1-pin) connector and daisy chain it to the TVK-10 (1-pin gray connector). Remove the original GPS connector from the radio, connect it to the female side of the GPS connector on the TVK-10. Then, connect the male side of the GPS connector on the TVK-10 to the monitor.
Need help?
Do you have a question about the TVK-10 and is the answer not in the manual?
Questions and answers