Roll Media - Datamax W-6208 Operator's Manual

3.1.1

Roll Media

This loading method is for roll type media applications. To load:
Slide Roll Media onto the Media
Supply Hub until it rests against the
Backstop.
Route the media as shown below:
under the Bouncer Assembly, through
the Media Sensor, then out the front
of the printer.
Slide the Media Guide over until it
rests lightly against the edge of the
media.
Position the Media Sensor; see
Section 3.2.
If your application uses thermal transfer media, load ribbon (see Section
3.3); otherwise continue.
Lower the Printhead Assembly and rotate the Printhead Latch completely
back into the locked position. Close the Access Cover.
Turn 'On' the printer. After 'Ready is displayed, press and hold the FEED
key until at least one label gap or mark is advanced; see Section 3.4.
If using less than full width media, adjust the Leveling Cam; see Section
5.1.1.
W-Class 13