Hardware Installation - D-Link SECURICAM Network DCS-950 User Manual

DCS-950 User's Manual

Hardware Installation

Attach the External Power Supply
Attach the external power supply to the DC power input connector located on the rear
panel of the DCS-950 and connect it to your local power supply. Note: Power source is
confirmed when the orange LED Power Indicator located to the right of the lens on the
DCS-950 is illuminated.
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on the
back panel of the DCS-950 and attach it to the network. Network Connectivity is
confirmed when the green LED Indicator on the DCS-950 located below the Power
LED is illuminated.
D-Link Systems, Inc.
Hardware Installation
10