Component Video & Progressive Scan Connections - CyberHome LDV 702 Owner's Manual

Component Video & Progressive Scan Connections
3
Connecting to a TV with Component Video Inputs
Component Video separates the Video Signal into three separate "components", resulting in a higher
quality picture than S-Video or Standard Composite Video. In order to use Component Video, you
must use a TV equipped with Component Video Inputs. You'll also need (3) Component Video Cables
(included).
Step 1: Enter the Setup Menu to Change the Video Setting
With disc play stopped, press the SETUP button on the Remote Control to enter
the DVD Player's On-Screen Setup Menu. Use the ARROW keys to navigate
down to the VIDEO menu and press ENTER or Right Arrow Key. Use the
ARROW keys again to proceed down to the OUTPUT setting. Press ENTER and
then use the UP/DOWN keys to select YCbCr. Press ENTER to confirm your
choice.
Step 2: Connect the DVD Player using the Component Video Cables
At this point, connect the separate Component Video Cables to the appropriate jacks. Normally, cables and jacks are
color-coded to make connection easier. Power on TV and set your TV to the Video In Channel associated with the
Component Video inputs ("Video 3", "Input 3", etc.) You should now see the DVD Player splash screen on your TV.
TV
Step 3: If You Are Using a PROGRESSIVE SCAN TV
Now that you are using the Component Video Outputs, you can change the
OUTPUT setting to enable Progressive Scan mode. Do not change these settings
if you are not SURE your TV supports Progressive Scan.
Using the ARROW and ENTER keys, change the OUTPUT setting to YPbPr. The
DVD Player is now in Progressive Scan mode. Exit the setup menu by pressing the
SETUP button.
LANG.
VIDEO
AUDIO
CHILD
OTHERS
EXIT
For Help on Using the Setup Menu, see pg 38.
PROGRESSIVE SCAN /
COMPONENT VIDEO IN
Y
Cb
Cr
SYSTEM NTSC
ASPECT 4:3 PS
OUT PUT YPbPr
ENTER RETURN SETUP
GREEN OR YELLOW
BLUE
RED
18
Component Video
Connectors
For Help on Using the Setup Menu, see pg 38.
SYSTEM NTSC
LANG.
ASPECT 4:3 PS
VIDEO
OUT PUT YCbCr
AUDIO
CHILD
OTHERS
EXIT
ENTER RETURN SETUP
DVD DVD DVD DVD
Quick Tips
If you need to reset the
Player's Video Settings to
factory defaults, Reset the
player, Open the Disc
Cover and press "STOP -
2 - 0 - 0 - 2" on the
Remote Control.
VIDEO