Table of Contents
Advertisement
Connecting the video output to your TV
In order to use this DVD player with your TV, a few cable connections are necessary. The capabilities of your TV will determine the
connections you can use. There are 3 possible connection types:
Composite Video - The most widely used connection.
S-Video - A higher quality connection that requires the provided S-Video connector and an S-Video capable TV.
Component Video - The highest quality video connection. Supported on high-end televisions.
Composite Video (Typical connection)
Use the Composite / S - Video and Stereo Audio cable for connection to TVs with a standard video input as shown below. This is the
most widely used type of connection on TV's. The composite connector is colored yellow, and is normally accompanied by stereo
audio inputs, colored red and white for stereo channels right and left, respectively.
1
1
First, use the supplied Composite / S - Video cable to
connect to the composite video input jack on your TV.
This is normally a yellow-colored connector as pictured
below.
1 1
Composite / S - Video Cable
1 2
Analog Stereo Cable
VIDEO
OUTPUT
!
Important note for older TV models
If your TV does not have a composite video-in jack like that pictured above, you cannot connect this
unit directly. If this is the case, check to make sure your TV has at least a coaxial connector (used for
antenna/cable TV/VCR/etc.) such as that pictured to the right. If this is the case, you can use an RF
Modulator to convert this unit's video out to the coaxial connection on your TV. RF Modulators are
available at major electronics retailers.
DVD Player
AUDIO / VIDEO CONNECTIONS
11
10
Composite Video
Input Jack
Stereo Audio
Input Jacks
RF Modulator
2
If you wish to hear sound through the TV, connect the
included red and white analog stereo cable.
3
Turn on the TV and DVD Player.
4
On your TV, select the video input. This is normally done
by selecting "Video 1" or "Video Input" with the remote
control. On some TVs, this is done by selecting a
particular channel.
5
Press the "Monitor" key on the front panel of the DVD
player one time to change the video output mode.
6
You should now see the DVD players' splash screen on
the TV.
STEREO AUDIO IN
1 2
L
R
V
Rear Panel
Older TV with
antenna/cable
connector
17
TV with
Composite
VIDEO INPUT
Video Input
(Typical
Connection)
1 1
Antenna/cable TV
coaxial connector
on older TVs
coaxial
Advertisement
Table of Contents
