Related Manuals for Safety Track ST-203
Summary of Contents for Safety Track ST-203
- Page 1 ST-203 DashCam System Quick Install guide A quick guide on how to install your new system with an optional 3rd cam.
- Page 2 Unpacking the Box Installation Steps Contact Support This is a step by step guide that will walk you through installing your new ST-203 Dash Cam System. If you have any questions regarding this quick guide please contact our support team at...
-
Page 3: Unpacking The Box
Unpacking the Box The contents of each box are as follows: ST-203 Dash Cam 2. Power Harness 3. GPS Antenna (Square Shaped Antenna) 4. 4G Antenna (Blade Shaped Antenna) 5. Mounting Plate with 3M double sided tape to secure *Note: SD Card is already pre-installed in your system. If you need to remove the SD... -
Page 4: Installation Steps
Installation Steps Step 1: Consider and understand your mounting location for the DashCam as well as your 3rd camera if applicable. The most common placement of the Dash Cam is under the rearview mirror on most vehicles. *Please check your state and local laws if this placement will suffice. Below is an example placement in a Ford Explorer: Step 2: Locate your power source and run cable back to your... - Page 5 Our suggestion would be to connect all cables, power on by starting the vehicle and pull up the Safety Track Fleet App and check your view. There is a single adjustment screw on the mount of the camera to slightly adjust the angle.
-
Page 6: Contact Support
Step 5: Once your device is connected to power and you turn on the ignition. Your dashcam will “Beep” once to indicate powering up. The indicator lights will start to come on as the device powers up. Indicator lights on the front of the Dash cam are as follows: REC.
Need help?
Do you have a question about the ST-203 and is the answer not in the manual?
Questions and answers