Reloading Switches
If there are only two switches in the stack, the switch that was reloaded (the former secondary) resumes
the secondary role when it comes back up.
Primary - Slot 1
Secondary - Slot 2
-> reload secondary
Primary - Slot 1
Booting...
Primary - Slot 1
Secondary - Slot 2
Reloading the Secondary Management Module In a Stack of Two
page 6-28
Managing OmniSwitch 6400 Series Stacks
1
In this stack of two OmniSwitch 6400 Series switches, the slot 1
switch is the primary management module. The slot 2 switch is
the secondary.
2
The user reloads the stack's secondary management module by
issuing the reload secondary command. Any data flow on the
secondary switch's Ethernet is interrupted.
3
As the secondary switch reboots, the primary management mod-
ule continues to operate without interruption. Meanwhile the
stack has no interim secondary management module as the switch
reboots.
4
When the rebooted switch comes back up, it assumes the secondary
management role within the stack.
OmniSwitch 6400 Series Hardware Users Guide
July 2010