Table of Contents
Advertisement
BIND IPX JT1ODI_1_EII NET=xxxx
LOAD C:\NWSERVER\JT1ODI SLOT=1
FRAME=Ethernet_SNAP
NAME=JT1ODI_1_ESP
BIND IPX JT1ODI_1_ESP NET=xxxx
6. Restart the server again.
Parameters supported by the JT1ODI.LAN driver
SLOT 1 – Forces the driver to search for the specified card.
FULLDUPLEX – The FULL-DUPLEX parameter causes
the JT1ODI to operate in full-duplex mode. When
operating in full-duplex mode, the JT1ODI can
simultaneously transmit and receive packets.
AUTONEGOTIATE – The AUTO-NEGOTIATE parameter
causes the JT1ODI to auto negotiate the duplex mode
and link speed with the device being connected.
TXDMATHRESHOLD – The TXDMATHERESHOLD
determines the I/O method used to move transmit
packets from host memory to the JT1ODI memory. The
valid range for the TXDMATHRESHOLD is 0 - 1514. the
default value is 800.
DISABLERXIP
–
Disables the JT1ODI TCP/IP Receive
Packet checksum support. By default, the JT1ODI will
perform TCP/IP checksum verification on received
packets in hardware if the operating system supports
this capability.
Due to the large number of Network Operating Systems
(NOSs) supported, detailed driver software installation
instructions are given in README.TXT files on the
1000Mbps
Gigabit
Ethernet Card Software Diskette.
14
Advertisement
Table of Contents
