Table of Contents
Advertisement
Software Installation
Windows NT v4.0
1. Make sure the network adapter has been installed in
your computer, boot it up, and start Windows NT 4.0.
2. Open My Computer → Control Panel → Networks.
3. Select Add adapter → Have disk.
4. Type the following: A:\ (where A: is the floppy drive)
5. Select Level One ...
6. Click OK and Windows NT 4.0 will copy the files from
the driver disk.
7. After the file has been copied, click Properties and
modify
the
1000Mbps
configuration.
8. Click OK after making the configuration setting changes.
Windows NT 4.0 will then ask you to reboot the PC.
Select YES.
9. Restart the computer.
Gigabit
Ethernet
10
Card
Advertisement
Table of Contents
