Description Of The "Dhw Set" Window (Fig. 42); Magis M System Settings (Fig. 43) - Immergas SMARTECH PLUS Instructions And Warnings

3.1.4 DESCRIPTION OF THE "DHW SET" WINDOW (FIG. 42).

42
By pressing the "DHW SET" button (Ref. 9 Fig. 41) you access the "DHW
setting" window (see Fig. 42), where it is possible to change the DHW
temperature setting.
Note: the table below refers to the "DHW SET" button (Ref. 9 Fig. 41)
Ref.
In this case it is possible to access this menu and set
Enabled
the DHW temperature setting
Disabled and The DHW mode is enabled but not active (OFF from
visible the Magis M remote panel)
Disabled and
The DHW mode is disabled from the Magis M remote
not visible panel (from the installer menu)
Description

3.1.5 MAGIS M SYSTEM SETTINGS (FIG. 43).

43
2
3
4
5
With reference to the Magis M system it is possible to select various settings
as shown in Fig. 43.
Ref.
Recycle Bin, this command deletes the entire Instal-
1
lation
2
It is possible to change the name of the system
It is possible to change the connection to the Wi-Fi
3
network to which the Gateway is connected
It is possible to enable/disable Remote Assistance to
4
allow the Immergas Assistance Centre to adjust the
Installation parameters
5
Account cancellation
29
1
Description