HOMCOM FRO2718-50 Instruction Manual page 9

: Press this button, the unit will enter standby mode. The indicator light
will be on. Then you can select the following functions as desired. Press
again to turn off the heater.
: Press this button to change flame color. There are ten types of flame effect.
Hold it for about 3 seconds to change top light color. There are seven types of
top light effects.
: Press this button to change the flame effect. Press repeatedly to decrease the
flame intensity. There are 5 light intensities with 5 being the brightest intensity
and 1 being the lowest intensity.
: Repeatedly press to adjust the desired room temperature. Press and hold the
temperature button for around 3 seconds to turn on the units heat function.
Press and hold the temperature button again for around 3 seconds to turn the
heat function off. The heat function can also be accessed using the remote
control.
Operation by the Remote Control
CAUTION：For better use experience, please use the remote control in front of the
heater. And do not exceed 5 meters away from the heater.
: Press this button to enter standby mode – the indicator light will turn on.
Now, you can select the desired functions. Press the button again to turn
off the heater.
: Adjusting the time function:
- Press this button and the 'SUN' on the LED screen will start flashing.
- Use the ↑ and ↓buttons to select the desired date, then press + to
confirm. To cancel, press-.
- After setting the desired date, press ++ for the 'hour' position.
- Use + or - to select the desired hour.
- Press ++ for the 'minute' position.
- Use + or - to select the desired minute.
- Press either ++ or OK to complete the setting.
NOTE: If there is a power interruption, the date will automatically reset.
: Automatic time adjustment:
- Press this button and the time serial number will flash. The 'ON' on the
LED screen will light up.
- Use the + or - to select the desired serial number.
- Press ++ again – the 'SUN' on the LED screen will start flashing.
- Use ↑ or ↓ to select the desired date. Press + to confirm or - to cancel.
- After setting the desired date, press ++ for the 'hour' position.
- Press + or - to select the desired hour.
- Press ++ for the 'minute' position.
- Press + or - to select the desired minute.
- Press ++ again. The 'ON' will turn off and the 'OFF' will light up. Set the
shutdown time in the same way as before.
- Finally, set the temperature at which the heater will stop heating. Press
+ or - to select the desired temperature. Once the desired ambient
temperature is reached, the heater will automatically stop heating.
8