HOMCOM FRO2718-50 Instruction Manual page 6

Step 3: Tilt the front glass panel to remove it. Ensure the power switch is in the OFF
position to allow the glass to pass it. Once the glass has passed the switch, you can
move the power switch to the ON position. Place the glass on a flat, soft surface in
preparation for reinstallation.
Fig. C
Step 4: The decorative bed has two sides – a glittery side and a matt side (refer to
Fig. D).
For the matt side: Remove the protective film from the decorative bed.
For the glittery side: Unscrew the three screws holding the decorative bed, flip it to
the desired side, then securely reattach the bed by tightening the screws.
Fig.D
5