Dimplex DCTF104DG Manual page 11

Operation
Manual Controls
1. Place the fan on a stable, flat surface. Plug the cord set into an appropriate electrical
outlet.
2. Turn the fan on by pressing the 'POWER' button. Turn the fan off by pressing the
'POWER' button again.
3. You can adjust the fan speed to the desired level: 1 (low), 2 (medium-low), 3 (medium-
high) and 4 (high) by pressing the 'SPEED' button. The speed setting is displayed
on the LED panel.
4. You can adjust the fan mode by pressing the 'MODE' button. The four modes are
'natural' 'normal' 'sleep' and 'child'.
5. To set the fans timer, press the 'TIMER' button. This allows you to set the fans length
of operation between 1-12 hours in intervals of 1 hour. To cancel the Timer function,
press the Timer button continuously until the timer light is no longer displayed.
6. To make the fan oscillate, press the 'OSCILLATION' button. This allows the fan to
oscillate up to 60° .
7. To toggle the operating sounds, press the 'MUTE/UNMUTE' button.
8. Turn the LED display temporarily off by pressing the 'DISPLAY ON/OFF' button
on the remote. The display will light up again once any control button is pressed.
Note: The LED display will turn off automatically after 30 seconds on inactivity. The
Display On/Off button can be held for three seconds after turning the LED display
on to cancel this feature. To re-enable the feature, press and hold the button for 3
seconds once again.
Operation Modes
NORMAL Mode
high). The fan will run continuously at the selected speed, and will not change
automatically
NATURAL Mode
natural mode, the fan will automatically switch circulation between fan speeds 2/3/4
based on the current selected fan speed to simulate natural wind.
SLEEP Mode - The sleep mode has 4 fan speeds (1, 2, 3, 4). When set to sleep
mode, the fan will automatically switch circulation between 1/2/3/4 fan speeds
based on the current selected fan speed in order to provide a comfortable breeze
during sleep.
CHILD Mode - The child mode is designed especially for children and babies.
The child mode has 3 wind speeds (1, 2, 3) which provide a soft airflow. The fan will
automatically switch circulation between 1/2/3 fan speeds based on the currently
selected fan speed. By default, oscillation is enabled in this mode. The oscillation can
be cancelled by pressing the Oscillation button.
- The normal mode has 4 fan speeds (1, 2, 3, 4, from low to
- The natural mode has 3 fan speeds (2, 3, 4). When set to
11