Troubleshooting Guide - RCA BRC11082 User Manual

Troubleshooting Guide

SYMPTOM
No power.
The remote control
does not function.
Very little or no sound
is coming from a DVD.
No picture.
The picture is not
clear.
Loud hum or noise is
heard.
Blu-ray Disc or DVD
does not play.
Picture-in-Picture (PiP)
does not work on a
Blu-ray Disc.
Specifications and external appearance are subject to change without notice.
BRC11082_ENG IB_20100902.indd 19
CAUSE (AND REMEDY)
• Ensure the AC power cord is connected.
• Make sure that the unit is turned on.
• Remove any obstacles between the remote and the unit.
• Use the remote near the unit.
• Point the remote at the remote sensor on the unit.
• Replace the battery in the remote with new one.
• Make sure plastic sheet has been removed from battery section.
• Make sure that you select POWER ON mode.
• Make sure the unit is not paused. Press the
• Make sure the unit is not in fast-forward or fast-reverse mode. Press the
button.
• Make sure the AUDIO/VIDEO input/output connections are correct.
• The unit has overheated. Shut it off for 30 minutes to allow it to cool down.
• The region number of the disc doesn't match the region number of this unit.
For DVD disc
• The disc is dirty. Gently clean the disc.
• The disc is scratched.
• The plugs and jacks are dirty. Wipe them with a cloth slightly moistened with
alcohol.
• Clean the disc.
• Make sure that the disc has the correct region code.
• There is no disc inside the unit ("No Disc" appears on the screen).
• Insert the disc correctly with the graphics facing up.
• Clean the disc.
• A non-NTSC disc has been inserted, or the disc region number does not match the
region number of the unit.
• Condensation may have formed inside the unit due to a sudden change in temperature.
Wait about an hour for it to clear and try again.
• Make sure that disc supports PiP mode.
PLAY button.
For Blu-ray disc
EN
PLAY
19
9/3/2010 10:27:09