Cal-Royal Genesys CGN Series Installation Instructions

Installation Instructions for CGN Genesys Series
4 INSIDE ROSE
6 INSIDE LEVER
TOOLS REQUIRED
PUSH PIN (PROVIDED)
NO. 2 PHILLIPS SCREWDRIVER
1/8-INCH DRILL BIT
5/16-INCH DRILL BIT
THIS LOCK IS FACTORY-PACKED 1-3/4" THICK DOOR
1. MARK DOOR
Hole
1" or 7/8"
Mark height line on edge and face of door. Detach stub
of template and mark center of door thickness on heightline.
Fold template at proper marking for bevel of door (high or low
bevel of flat). Position center line of tempplate on height line.
Hold in place and mark center
Point for 2-1/8" hole. And then the 1" or 7/8" hole.
Also mark for 5/16" holes for mounting screws.
10
7 LOCK BODY
6 ROSE INSERT
5 SCREW
#10-32UNF x 1-5/8"L
Height
Line
Hole 2-1/8"
Hole 5/16"
High edge of
bevel door
OUTSIDE PLATE
9
1 LATCH UNIT
SCREW
2
PHILLIPS HD
STRIKE
11
2. BORE HOLES
5/16" Holes
2-1/8" Holes
1/8"
Notches
Both
Sides
of door
Bore a 2-1/8" Holes and
5/16" holes. Bore holes from
both sides of door to avoid splintering wood.
NOTE: We recommend using a drill guide to
ensure straight holes. Bore a 1" or 7/8" hole straight
into door edge to intersect with center of 2-1/8" hole.
Use latchfront faceplate to pattern for cutoout.
Front should fit flush with door edge. Install latch
with screws provided.
(Wood door applications)
For proper alignment of lock chassis and lever,
cut out notched for anchor plate lugs from both
sides of door on horizontal height line.
Mortise for anchor plates on both sides
of door (see template).
NOTE: Width of notches should
not exceed 1/8" for snug of anchors.
OUTSIDE LEVER
6
OUTSIDEROSE ASS'Y
1" or 7/8"
Holes
LSG-2075-1 of 2 - 050124