Promaster Key Grip Video Monopod Kit Quick Start Manual page 4

video head and tighten the
slide the QR plate back and forth within the
tightening the QR knob. Note the location of the plate using the numbered scale on the
for future, repeatable mounting in the same place. Notice that the
can pull outward on it, rotate it to a new position, and let go of it. This will change the phase position
of the knob without loosening or tightening it. This repositionable feature allows you to set the
knob to the most convenient resting place.
The QR plate's anti-twist pin
and lens mounting rings. If your camera or lens does not have this hole, the spring-loaded pin will
retract on its own as the
from the bottom of the
On the bottom side of the
plate and your camera from sliding off the top of the
The safety bolts can be removed if you choose using the
Removing the bolts will allow the
eliminate the safety feature. We do not recommend removing the
Anti-twist pin
REMOVING AND MOUNTING THE HEAD
You may choose to remove the included
wish to mount the Key Grip
Locate the 2.5mm hex key
the hex key to loosen the
platform. Ensure the
video head with one hand and the upper section of the monopod with your
other hand. Turn these two parts counterclockwise to loosen them from each
other. Continue turning the head until it is fully released from the monopod.
You can now mount a different head to the
platform. Once the head is installed, be sure to re-tighten the
secure it in place.
QR knob to hold it in place. When mounting your camera to the head,
is designed for an anti-twist hole found in the bottom of some cameras
QR plate is installed. If preferred, you can remove the pin by unscrewing it
QR plate with a flathead screwdriver.
QR plate you will notice two protruding
QR plate
¼"-20 mounting bolt
/ "-16 mounting
3
8
bolt
video head
video head to a different monopod, tripod, or grip item.
stored within the Key Grip's
grub screw found on the underside of the
pan lock knob on the head is tight. Take ahold of the
QR platform to find the best balance point before fully
video head
2.5mm hex key
to slide into the top of the
and install a different type of head. Or you may
control
/ "-16 connection on the
3
8
grub screw
(3)
QR knob is repositionable—you
safety bolts. These prevent the
if the QR knob is loosened accidentally.
stored in the
video head more easily, but will
safety bolts from the
Safety bolts
handle. Use
monopod
monopod
to
QR platform
QR
QR
control handle.
QR plate.
Soft cover
Grub screw