Specifications - Simplex VESDA-E VEU IDNet Product Manual

2.5

Specifications

Note: The specifications section incorporates the values for the integrated unit.
Table 2-1: 4098-VEU VESDA-E IDNet Detector Specifications
Specification Value
Supply Voltage 18 to 30 V DC (24 V DC Nominal)
Peak Current 1.5 A
Maximum current Quiescent: 0.84 A
consumption:
In alarm: 0.88 A
Power
Consumption @24
V DC
Aspirator Setting
Current (Quiescent)
Current (In Alarm)
Ethernet Active Add 0.01 A
WiFi Active Add 0.02 A
Dimensions 13.8 in x 8.9 in x 5.3 in (350 mm x 225 mm x 135 mm)
(WxHxD)
Weight 11.88 lbs (5.39 kg) (4098-VEU-A00)
11.88 lbs (5.39 kg) (4098-VEU-A10)
Operating Temperature:
Conditions
l
Please consult your
l
Simplex representative
* Sampled Air temperature shall reach Ambient Detector temperature upon entry into detector. Refer to
for information on
Xtralis Design Guides and Application Notes for sampled air pre-conditioning.
operation outside these
parameters or where
Humidity:
sampled air is continually
above 0.05% obs/m
l
(0.015% obs/ft) under
normal operating
conditions.
Storage Conditions
l
l
(Non-operational)
l
Relays
l
l
Connection to the Direct connection to the IDNet loop through recommended wiring
Fire Alarm Control
Panel
Cable Termination Screw terminal blocks (0.2-2.5 sq mm, 24-14 AWG)
IDNet connection from IFC card terminal block (0.75 – 2.5 sq mm,18-14 AWG)
Dynamic Range 0.0000%/ft to 10%/ft (0.000%/m to 32%/m)
Sensitivity Range 0.0003 to 6.25% obs/ft (0.001% - 20.0% obs/m)
https://simplex-fire.com
1
0.28 A
0.32 A
Detector Ambient: 0°C to 38°C (32°F to 100°F)
Sampled Air: 4°F to 140°F (-20°C to 60°C) *
5-95% RH, non-condensing
Humidity: Dry (<95%)
Temperature: 0° to 85°C
Must not be exposed to sunlight or other radiation sources
7 pre-configured relays (non-latching states)
Contacts rated 2 A @ 30 VDC (Resistive)
Simplex VESDA-E VEU IDNet Detectors Product Guide
4098-VEU-A00
5 10
0.36 A 0.59 A
0.40 A 0.63 A
4098-VEU-A10
1 5 10
0.32 A 0.40 A 0.63 A
0.35 A 0.43 A 0.66 A
7