B Connecting To A Tv Set And An Amplifier With A Digital In Jack - Aiwa XD-DV370 Operating Instructions Manual

CONNECTIONS (CONTINUED)

B Connecting to a TV set and an amplifier with a Digital In jack

Use either the commercially available optical cord or 75 ohm coaxial cord when connecting this unit to an AV amplifier with
a Digital In jack. The supplied video cord is also available instead of the coaxial cord.
21 pin scart cable (not supplied)
to 21 pin scart
connector
When your TV set is equipped with an S-video input terminal, see page 17.
Set the setup menu correctly after connecting!
According to the audio equipment and TV set to which the
unit is connected, set the "Digital Audio Output" and "TV
Aspect" of the setup menu correctly referring to the
following below.
See "CHANGING SETUP VALUE" on page 39 in detail.
Digital Audio Output
PCM
12
DIGITAL OUT
COAXIAL
DIGITAL
S-VIDEO
OUT
OUT
OPTICAL
to DIGITAL OUT
to DIGITAL OUT
COAXIAL jack
OPTICAL jack
Optical cord (not supplied)
Front
Amplifier with a Digital In jack
speaker (L)
to 21 pin scart
connector
AUDIO
OUT
L
R
NTSC
PAL AUTO
VIDEO
OUT
or Coaxial cord
(not supplied)
to a digital input jack
Front speaker
(R)
TV Aspect
When your TV set is a conventional-screen size TV:
4:3 Letter box
When your TV set is a wide-screen size TV:
16:9 Wide
NOTE
When the picture noise appears while copy-protected DVDs
are played, connect the unit directly to a TV set. Do not
connect through a VCR, TV/VCR or AV selector.
TV set
Rear of the unit
to an AC power socket
(AC 230 V, 50 Hz)