Download Print this page

Specifications - MetalTech CLIMB-N-GO I-CNG Operational Safety And Assembly Instructions

Motorized system for baker type scaffold
Hide thumbs Also See for CLIMB-N-GO I-CNG:

Advertisement

Available languages

Available languages

ELECTRONIC SAFETY RULES
Do not expose batteries, cables or other electronic components to outdoor weather
or wet conditions.
Do not use this product with defective or damaged batteries.
Never use the cables for carrying, pulling, or unplugging the electrical device. Keep
cables away from heat or sharp edges.
Make sure that all cables are properly affixed to the scaffolding, so that they will
not be rolled on, tripped over or subject to damage while in use.
Always disconnect the battery from the Climb-N-Go® before making any adjustments
or repairs.
Do not use with a damaged cable or any other damaged electronic component.
Replace immediately any damaged parts with official replacements parts from
Metaltech. Do not use until the damaged parts have been replaced.
Do not disassemble or modify the electronic components inside the Climb-N-Go®
other than for replacing defective parts.
The cables must be plugged into the connectors, respecting their orientation.Never
modify a connector or apply excessive force when connecting.
Metaltech declines all responsibility for damages caused to batteries with the use
of this product.

SPECIFICATIONS

WEIGHT
RANGE
HAULING CAPACITY
BATTERY VOLTAGE
CAN BE POWERED BY
COMPATIBLE INTERIOR
SCAFFOLDING
COMPLIANCE
All trademarks listed above, including DeWalt, Makita, Milwaukee, Porter Cable, Black & Decker, Bosch and Stanley are the property of
their respective owners. Neither Metaltech nor its products are in any way affiliated with, authorized with or have been tested, certified or
approved by any of the companies or trademarks listed above, including for use with any of these companies' batteries.
*The Climb-N-Go® has been specifically designed for use with Metaltech Baker type scaffolds and not with other brands.
55.1 LB (25 KG)
4,500 FT (1,372 M) (tested with 20V 4.0Ah battery)
500 LB (227 KG)
18-21V (NOT INCLUDED)
DEWALT®, MAKITA®, MILWAUKEE®, STANLEY® (18V), PORTER CABLE®,
BLACK & DECKER®, BOSCH®
METALTECH BAKER TYPE SCAFFOLDING*; I-CISC, I-CISCH1, I-CISCTP , I-CISCPY,
I-CISCMT, I-CAISC, I-CISCDW AND I-BMSS
CSA S269.2-16 AND OSHA 1926.452(W)
5

Advertisement

loading
Need help?

Need help?

Do you have a question about the CLIMB-N-GO I-CNG and is the answer not in the manual?

Subscribe to Our Youtube Channel