Operational Safety - MetalTech CLIMB-N-GO I-CNG Operational Safety And Assembly Instructions

OPERATIONAL SAFETY

READ CAREFULLY BEFORE USING THIS PRODUCT.
FAILURE TO UNDERSTAND AND FOLLOW ALL SAFETY RULES AND ASSEMBLY
INSTRUCTIONS COULD RESULT IN SERIOUS INJURY OR DEATH.
WARNINGS
Do not use this equipment if you are in poor health, taking medication, drugs, or
have been consuming alcohol, all of which may impair your ability to work safely
with this product.
Always use this product in conformity with local or national legislation which
applies.
Respect any applicable local or national legislation regarding the speed and height
of use of the Climb-N-Go® with scaffolding.
Read and understand this entire manual before using this product. If you have any
questions, contact our customer service.
Follow all safety instructions and warnings of the scaffolding that will be used with
the Climb-N-Go®.
Read and follow the manufacturer's operating and safety instructions of the battery
used with the Climb-N-Go®.
Never climb up into the scaffolding if the Climb-N-Go® wheels are not in active lock
mode.
Climb up or down the scaffolding from the opposite side where the
Climb-N-Go® is installed to provide a counterweight whether using the ladder or
the access hatch.
Install the Climb-N-Go® on the opposite side of the platform access hatch if the
scaffolding has one.
Always use scaffolding with a guardrail when using the Climb-N-Go®.
This product is designed to be used and stored indoors.
The surface on which the scaffolding is moved must be less than 3 degrees in slope,
without pits, debris, holes or obstacles.
The Climb-N-Go® is designed for use with a single scaffold. Do not use this product
to move stacked scaffolding units.
Never pass through door openings or low clearance areas while driving a scaffolding
equipped with the Climb-N-Go®. Always get down the scaffolding, set the Climb-N-
Go® wheels to "Free-Mode", and push it into low clearance areas manually.
Acids are corrosive and can seriously affect strength. Do not expose the Climb-N-
Go® to corrosive substances.
Metaltech declines all responsibility for damage to batteries caused by using this
product, to the Climb-N-Go® or its components by improper use of the product.
4