Certification; Regulations (Directives, Laws, Standards) - Vaillant ecoTEC plus Instruction Manual

▶ To facilitate the installation, use only wa-
ter, standard commercial soft soap or, if re-
quired, the supplied lubricant.
Mortar residues, shavings, etc., in the flue
gas route may prevent the flue gas from flow-
ing outdoors as intended, and this flue gas
may escape into the dwelling instead.
▶ After installation, remove all mortar
residues, shavings, etc., from the air/flue
pipe.
1.3.4 Requirements for the air/flue terminal
As a result of improper installation, water may
penetrate the building and cause material
damage.
▶ Observe the requirements for the air/flue
terminal in the boiler's installation instruc-
tions.
1.3.5 Risk of material damage caused by
using an unsuitable tool
▶ Use the correct tool.
1.4

Certification

The heat generators are certified as gas-fired
boilers with associated flue system. This set-
up instructions are a component of the cer-
tification and are cited in the type test certi-
ficate. In compliance with the regulatory stat-
utes of these set-up instructions, the proof of
usability of the elements identified by Vaillant
article numbers that are designed for the
air/flue pipe is provided. If you do not use cer-
tified Vaillant air/flue pipe elements when in-
stalling the heat generators, this voids the CE
conformity of the heat generator. We there-
fore strongly recommend that you fit Vaillant
air/flue systems.
1.5 Regulations (directives, laws,
standards)
▶ Observe the national regulations, stand-
ards, directives, ordinances and laws.
4
Air/flue pipe installation manual 0020235221_04