Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HIKVISION DS-TMG034
Summary of Contents for HIKVISION DS-TMG034
- Page 1 Radar(DS-TMG034) User Manual...
- Page 2 INTERRUPTION, OR LOSS OF DATA, CORRUPTION OF SYSTEMS, OR LOSS OF DOCUMENTATION, WHETHER BASED ON BREACH OF CONTRACT, TORT (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS.
- Page 3 Radar User Manual PRODUCTION OF CHEMICAL OR BIOLOGICAL WEAPONS, ANY ACTIVITIES IN THE CONTEXT RELATED TO ANY NUCLEAR EXPLOSIVE OR UNSAFE NUCLEAR FUEL-CYCLE, OR IN SUPPORT OF HUMAN RIGHTS ABUSES. IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATTER PREVAILS.
- Page 4 Radar User Manual Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Indicates a hazardous situation which, if not avoided, will or could Danger result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, Caution could result in equipment damage, data loss, performance degradation, or unexpected results.
-
Page 5: Table Of Contents
Radar User Manual Contents Chapter 1 Introduction ....................... 1 1.1 Product Introduction ......................1 1.2 Radar logic ..........................1 Chapter 2 Installation ......................... 3 2.1 Installation ..........................3 2.1.1 Trigger radar ....................... 3 2.1.2 anti-fall radar ......................4 Chapter 3 configuration ......................5 3.1 Software Installation ...................... -
Page 6: Chapter 1 Introduction
Radar User Manual Chapter 1 Introduction 1.1 Product Introduction This document is a guide for radar installation and debugging. When the radar is used as the trigger device or anti-fall device in the E&E system, you can refer to the following debugging steps. The advantages of radar are convenient installation, low construction cost and stable triggering of passing objects, while the disadvantages are easy to cause false triggering 1.2 Radar logic... - Page 7 Radar User Manual...
-
Page 8: Chapter 2 Installation
Radar User Manual Chapter 2 Installation 2.1 Installation 2.1.1 Trigger radar The installation height of the radar is 60CM, and the installation position should be about 4 meters away from the camera. After determining the location, it should be fixed by expansion screws. The red and black wires of the radar are power cables, and the yellow and brown wires are signal cables, which are connected to the IO port of the camera. -
Page 9: Anti-Fall Radar
Radar User Manual 2.1.2 anti-fall radar The anti-collision radar is installed at the side of the lane gate and installed through the reserved hole of the lane gate. The red and black wires of the radar are power cables, and the yellow and brown wires are signal cables, which are connected to the induction port of the barrier. -
Page 10: Chapter 3 Configuration
Radar User Manual Chapter 3 configuration After the installation completes, power on the radar, starting to debug the radar 3.1 Software Installation Click the QR code below to download and install software 3.2 Connecting Radar Select STJ79-3 to enter the software, click the upper left corner, and select "WiFi connection"... -
Page 11: Language Switch
Radar User Manual 3.3 language switch Click on the right side of the software and then click on language to select English. If the phone is an Apple OS, the software language is the same as the system language. There is no need to switch... -
Page 12: Radar Parameters
Radar User Manual 3.4 Radar Parameters Radar related parameters acquisition: In the main interface of read radar parameters list you can choose to read back various information and parameters of the radar, the returned firmware version, SN, time is displayed at the upper small speaker, the detection parameters and radar information will generate a new page to display. -
Page 13: Radar Parameters Setting
Radar User Manual 3.5 Radar Parameters Setting Trigger Radar: Select Trigger mode and select "Yes" in FilterSingle. Anti-Fall Radar: Select Single Boom Pole-Anti-Fall mode and select "No" in FilterSingle. Other parameters are set as follows ①The maximum detection distance is set to the actual pole length (can be set in the range of 0.1-6m) - Page 14 Radar User Manual ②The Minimum detection distance set by default 0.3m (can be set in the range of 0.1-6m) ③The left and right side width Detection range setting both default 1m. ④Pole falling time should be set the default is 6s. ⑤Detection direction setting: Do not setting，keep the defult Any.
-
Page 15: Wifi Setting
Radar User Manual 3.6 WiFi Setting WiFi settings: In the system information menu, click WIFI/BLE to get the radar WiFi name and password and version, and you can also modify the radar WiFi name and password to distinguish the current device in multiple radar scenarios. -
Page 16: Radar Detection
Radar User Manual 3.7 Radar Detection Radar target detection: during installation and commissioning or later maintenance, if there is a false trigger or no fall of the pole, you can click "open" to display the target detected by the radar in real time in the form of points in the coordinate system in real time, easy to investigate. -
Page 17: Firmware Upgrade
Radar User Manual 3.8 Firmware Upgrade In the upgrade menu, use the "Select Firmware" button to import the firmware upgrade package via WeChat file or local path, and then click ”upgrade”.
Need help?
Do you have a question about the DS-TMG034 and is the answer not in the manual?
Questions and answers