Troubleshooting - Quatech QSC-200 User Manual

11 Troubleshooting

Listed here are some common problems and frequent causes of those problems. If the
information here does not provide a solution, contact Quatech technical support.
Any unauthorized repairs or modifications will void the QSC-200/300's warranty.
Computer will not boot up.
1. Is the QSC-200/300 properly inserted? Remove the card and try again. Perhaps try a
different expansion slot.
2. Ensure that an ISA-bus card is not using the same IRQ that the PCI BIOS tries to assign
to the QSC-200/300. Most computers have BIOS setup options to reserve IRQs for either
ISA or PCI use. Try reserving the IRQ for the ISA card. The BIOS will automatically
choose a different IRQ for the QSC-200/300. An address conflict is unlikely because
most PCI-based computers will assign I/O addresses in such a way that they cannot
conflict with ISA-bus devices.
3. The QSC-200/300 may be defective. Contact technical support for instructions.
Cannot communicate with other equipment.
1. Are the cable connections correct? Are the cables securely attached?
2. Is the software configured with the correct base address and IRQ information for the
QSC-200/300? (This is mainly a DOS issue.)
3. Is the device driver installed?
4. If you are trying to communicate with another DTE, a null-modem cable will be required.
5. If possible, use a loopback connector to test the port.
Quatech QSC-200/300 Users Manual 38