Inner Door Reversal - JUNO JKI 1333 Operating Instructions Manual

Table of Contents

Advertisement

D
D130
(C) and hinge cover (D) into position.
D128
B B
D013
H
D094
12
Fig. 4
Open the door and
push the appliance
against the side of
kitchen furniture op-
posite to that of ap-
pliance hinges.
Fasten the appliance
with 4 screws pro-
vided in the kit in-
C
cluded with the ap-
pliance. Snap vent grill
Fig. 5
Press in the joint
covers between the
appliance and the
kitchen furniture.
Fig. 6
Apply covers (B) on
joint cover lugs and
into hinge holes.
Fig. 7
Position the runners
(H) at the top and
bottom of the inside
of the kitchen unit as
shown in Fig. 7 and
mark the position of
the external holes.
After preparing the
holes, screw the run-
ners to the kitchen
u n i t d o o r u s i n g
3.5x16 mm screws.
8mm
PR34
PR35
clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.

Inner door reversal

(Only for model JKI 1333)
Slide out pin (1).
Remove the inner door, taking care that pin (4) does
not fall.
Remove bush (5) and fit it into the opposite corner of
the door.
Remove catch (3) by undoing the screw and refit it on
the opposite side.
Move pin (4) to the hole in the opposite side of the
door.
Position the door pressing pin (1) into place.
3
2
5
D164
Fig. 8
Open both the appli-
ance door and that
of the kitchen unit to
approx. 90 .
Place the little plates
over the runners.
Hold the doors of the
appliance and the
unit together and
mark the holes.
Fig. 9
Remove the little
plates and make the
holes with a diam. of
2 mm. Replace the
little plates over the
runners and screw in
the screws provided
(3.5x16 mm).
For the alignment of
the kitchen unit door,
if necessary, use the
(Fig. 10)
Fig. 10
4
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jki 1033

Table of Contents