Refer to relevant instructions. There are working parts in this appliance which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instruc- tions.
The appliance must be earthed. The appliance should be installed well away from The power supply cable plug is provided with a con- sources of heat such as radiators, boilers, direct sun- tact for this purpose. If the domestic power supply light etc.;...
Building-in instructions If after having carried out the operation described in section 2 there is still some space left between the ap- Dimensions of the recess pliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A).
Fig. 9 D013 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 7 and mark the position of the external holes. After preparing the holes, screw the runners to the D416 kitchen unit door using 3.5x16 mm screws.
(approx. 4 mm). to a minimum; do not exceed the storage period spec- Do not use metal tools to remove the frost – they can ified by the manufacturer; when the freezer has not cause serious damage.
Periodic cleaning If the light does not come on when the door is open, check that it is screwed into place properly. Clean the inside with warm water and bicarbonate of If it still does not light up, change the bulb.