Starting-up Positioning Temperatur control Electrical connection Fresh food refrigeration Door reversibility Inner arrangement Inner door reversal Freezing fresh food Instructions for totally built-in appliances Storage of frozen food Thawing Ice-cube production Defrosting Maintenance Periodic cleaning Periodic of non-operation Interior light...
Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings.
Open the door and turn the thermostat control knob, Cooked foods, cold dishes, etc..: these should be to be found on the upper right hand side of the inner covered and may be placed on any shelf. compartment, clockwise beyond position «O» (OFF) Fruit and vegetables: these should be thoroughly to start the appliance.
To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. D293...
However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. pull out the plug from the wall socket or turn the thermostat knob to the «O» setting; 2. remove any stored food, wrap it in several layers of newspaper and put it in a cool place;...
The thermostat is set too high. Traces of water on the bottom of the refrigeration compartment. Check that the defrosting water discharge hole is not obstructed. Technical specifications The technical data is indicated in the rating plate on the left side inside the appliance.
(A). 4. Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance.
Page 10
6. Apply covers (B) on joint cover lugs and into hinge holes. 7. Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes.
Need help?
Do you have a question about the JKI1433 and is the answer not in the manual?
Questions and answers