Refer to relevant instructions. There are working parts in this appliance which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. See installation instruc- tions.
Remove the upper and lower screws (1) and pivots (2) tact for this purpose. with the safety washer (4) on the left side (Fig. 2). Re- If the domestic power supply socket is not earthed, move the door stop hinge (3-Fig. 3).
“gap”, measur- Remove the upper right screw and pivot. Straighten ing 50 mm deep by 540 mm wide (Fig. 5), must be the safety washer (4) of the lower right hinge. Remove provided in the rear of the kitchen unit.
Thawing pull out the plug from the wall socket or turn the ther- Deep-frozen or frozen food, prior to being used, can mostat knob to the «O» setting; be thawed in the refrigerator compartment or at room...
Periodic cleaning If the light does not come on when the door is open, check that it is screwed into place properly. Clean the inside with warm water and bicarbonate of If it still does not light up, change the bulb.