Page 2
Explanations of the technical terminology used in the operating instructions can be found at the end in the section "Technical Terminology". The operating instructions contain instructions for the correction of possible malfunctions by the user in the section "What to do, if ...".
• If the a malfunction occurs on the appliance, Keep packaging material away from children! please look first in the "What to do if ..." section of • Please make old appliances unusable prior to dis- these instructions. If the information given there posal.
This applies to your old • The appliance may not be disposed of with appliance, and - at the end of its service life - for your domestic waste or bulky refuse. new appliance as well.
– only be installed at a location whose ambient temperature corresponds to the climate classi- fication, for which the appliance is designed. The climate classification can be found on the rating plate, which is located at the left on the inside of the Climate for an ambient appliance.
The function and life of the appliance are not impaired. The warmed air must be able to be exhausted upwards through the air shaft (min. 200 ) on the furniture back. If the appliance is ventila-...
Freezer compartment Variable door storage compartment (for storage and freezing) Door storage compartment Rating plate Bottle compartment Prior to Initial Start–Up 1. Please clean the appliance interior and all acces- sories prior to initial start-up (see section: “Clean- ing and Maintenance”).
Approx. 38 °C 1 to 2 then runs automatically. Note: At a setting of "2“ up to "3“ the fridge has an Note: At the setting given under „recommendet set- average temperature of approx. +5 °C. tings“ the fridge has an average temperature of 3.
The remaining storage shelves can be adjusted to various heights: 1. Pull the storage shelf forward until it can be tipped up or down and removed. 2. To insert at a different height use the same proce- dure in reverse.
– extra–thick aluminium foil. • Do not freeze too large quantities at any one time (up to max. 2 kg in 24 hours). You will achieve a • The following are suitable for sealing bags and better quality if the food is quickly frozen through wrap: to the core.
Remove pieces of ice that have fallen before they completely defrost. 5. After defrosting, thoroughly clean the freezer com- partment (see "Cleaning and Maintenance" sec- tion). 6. Put the food inside and put the unit back into oper- ation.
5. After cleaning wipe with fresh water and rub dry. 6. Check the water drain hole on the rear wall of the • The appliance must be dry before it is placed back fridge.
What to do if ... Correcting Malfunctions A malfunction may be caused by only a minor fault Warning! Repairs to refrigerators/freezers that you can rectify yourself using the following may only be performed by qualified service instructions. Do not perform any other work on the engineers.
Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. Light bulb data: 220-240 V, max. 15 W, fitting: E 14 1. To switch off the appliance, turn the temperature regulator to position "0".
Inserting the appliance door....39 Adjust height ......38 Aligning the appliance door (if necessary) .
Page 18
The following installation steps are illustrated only when the door is hinged on the right (as supplied). If you want the door hinged on the left, please carry out the following installation steps on the opposite side as appropriate.
Page 19
Attach the grille, push appliance into place Screw appliance into place Install screw-head caps Attach decor panel Inserting the appliance door Aligning the appliance door (if necessary)
Need help?
Do you have a question about the JKE4435 and is the answer not in the manual?
Questions and answers