pTron Fusion Bold User Manual

Important : pTron 'Fusion Bold ' speaker is set at 50% default volume. You can increase the volume through the
Speaker or speaker remote or through the connected device.
Getting Started & Charging:
i. Unbox the Party Speakers and remove all packaging materials.
Place the speakers on a flat surface.
ii.
iii. Connect the USB type C cable to the charging port on the speaker's backside, and connect the USB end of the
Charging cable to a Power Source such as a USB Charger or other Charging Devices with a 5 volt(DC) output.
iv. Charge the speakers fully before initial use for the best battery performance.
Bluetooth Pairing:
i.
Turn on the party speakers by rotating the knob button.
ii. On your smartphone or tablet, enable Bluetooth and search for nearby devices.
iii. The speaker will enter pairing mode automatically.
iv. When you see "pTron Party Speaker" in the list of available devices, select it to pair.
v. Once the speaker is connected with the BT device it will respond with a voice prompt, "ptron Bluetooth speaker
is connected"
Note: If no device is connected within 5 minutes after turning on the speaker, the Speaker will automatically turn off.
Basic Operation:
Power on/off:
i.
Turn on the party speakers by rotating the knob button.
ii. Volume control:
Rotate the knob button to increase or decrease the volume.
iii. Play/Pause: Press the play/pause(
iv. Next/Previous track: Press one time "
music.
v. Mode Button:Long Press once the "M" button to change the speaker mode (Bluetooth and FM mode)
Note:
i.
You can also control the above basic operation with the remote, which is provided with the speaker. The speaker
will automatically detect the Aux, TF card and USB drive after inserting these devices.
ii. The charging cable works as an FM antenna in FM mode, so it is mandatory to connect the charging
cable in FM mode.
LED Light Show:
i. This speaker comes with built-in LED lights that add excitement to your party atmosphere.
Long press the "Light" button to activate the LED lights. You can cycle through different lighting modes by long
ii.
pressing the "light" button multiple times.
Fusion Bold BT Speaker - User Guide
) button to start or pause audio playback.
" buttons to move to the next or previous track when playing
" or "