Connections - Aiwa XR-M35 Operating Instructions Manual

CONNECTIONS
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120 V
AC. Check that the rated voltage matches your local voltage.
IMPORTANT
Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord in the end.
There are no differences between the front speakers. Both
speakers can be connected as L (Left) or R (Right).
1 Connect the speaker cords to the main unit.
The cords with the white stripes should be connected to the
~ terminals and the other cords to the O terminals.
@
d
Q
o
2 Connect the supplied antennas.
Connect the FM antenna to the FM 75 Q terminals and the
AM antenna to the AM LOOP terminals.
3 Connect the AC cord to an AC outlet.
When the AC cord is connected for the first time, the display
window demonstrates the functions of the unit. When the power
is turned on, the demonstration display is overridden by the
operation display. When the power is turned off, the
demonstration mode is restored.
To cancel the demonstration
Press the DEMO button or turn the MULTI JOG dial right or left.
To activate, press the DEMO button again.
Do not short-circuit the ~ and
O
speaker cord leads; otherwise
the sound may become inaudible or the unit may be turned off.
If this happens, disconnect the AC cord from the AC outlet and
re-connect the s~eaker cord correctlv. Connect then the AC cord
.
and turn the unit on again.
2
AM antenna
~T
D
FM antenna
Speaker cord 3
AC cord
3
ENGLISH