Aiwa XR-M33 Operating Instructions Manual page 13

Sound adjustment during recording
The output volume and tone of the speakers or headphones may
,;g';
be freely varied without affecting the recording.
;g;$,
This section explains how to record from the tuner, CD player,
or ,external equipment.
Preparation
Use Type I (normal) tapes only.
MODE
FUNCTION
II
Set the tape to the point where recording will start.
1
2
3
4
Insert the tape to be recorded on into deck.
Insert the tape with the side to be recorded on first facing out
from the unit and the exposed side down.
Press TAPE/RE'V MODE to select the reverse
mode.
'To record on one side only, select Z
'To record on both sides, select =] or C=).
Press function (TUNER, AUXAflDEO or CD) and
Iprepare the source to be recorded.
To record from a CID, press CD andl load the disc.
To record from a radio broadcasl, press TUNEWBAND
{andtune in to a station.
?o record from a connected source, press AUXAflDEO and
Iplay.
Press REC/REC MUTE
to start recording.
When the selected function is CD, playback and recording
start simultaneously.
m
To stop recording, press .
To pause recording, press II (applicable when the source is
TUINER or ALDVVIDEO). To resume recording, press it again.
Insertion of 4-second blank spaces may help you to locate Ithe
beginning of the track on other equipments. This unit can add
blank spaces only when the source is TUNER or AUX/VIDEO.
1 Press REC/REC MUTE during recording or while in
recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode,
2 Press II to resume recording.
To insert a blank soace of less than 4 seconds, press
REC/REC MUTE again while ~ is flashing.
To insert blank s~aces of more than 4 seconds, alter the deck
enters the recording pause mode, press REC/iREC MUTE
again.
Each time OREC/REC MUTE is pressed, a 4-second blank
space is added.
'This unit does not have the function to locate the beginning of track.
m
Recording cannot be done when TAPE function is selected.
To erase a recording
1 Insert the tape to be erased into the deck.
2 Set the tape to the point where the erasure is to be started.
3 Set the reverse mode by pressing TAPE/REV MODE.
4 Press AUWVIDEO and turn the connected equipment off.
5 Press REC/REC MUTE to start the erasure.
ENGLISH
12