Page 1
Wireless Access Point Quick Start Guide Punto de Acceso Inalámbrico Guía de inicio rápido Ponto de acesso sem fio Guia de início rápido Wireless Access Point Panduan Cepat...
Page 2
CONTENTS English Español Português Bahasa...
Products described in this Document, which may include licenses obtained from third parties. Any part of the Document, including text, pictures, graphics, etc., belongs to Hikvision. No part of this Document may be excerpted, copied, translated, or modified in whole or in part by any means without written permission.
Page 4
English USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS. YOU ACKNOWLEDGE THAT THE NATURE OF THE INTERNET PROVIDES FOR INHERENT SECURITY RISKS, AND HIKVISION SHALL NOT TAKE ANY RESPONSIBILITIES FOR ABNORMAL OPERATION, PRIVACY LEAKAGE OR OTHER DAMAGES RESULTING FROM CYBER-ATTACK, HACKER ATTACK, VIRUS INFECTION, OR OTHER INTERNET SECURITY RISKS;...
English Applicable Models This manual is applicable to the DS-3WAP521-SI access point. Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Provides additional information to emphasize or supplement Note important points of the main text.
English Chapter 1 Device Installation Note Never place the device in an unstable location. The device may fall, causing serious personal injury or death. Install safety protection equipment if necessary. Check regularly. It is recommended to install the device according to the following instructions. We are not responsible for any results coming from individual arbitrary modification or installation.
Page 7
English Table 1-2 Packing List Item Quantity Smart Managed Access Point × 1 Screw Pack × 1 Quick Start Guide × 1 Regulatory Compliance and Safety Information × 1 Remove the cover of the AP and then view the device label as shown in the following figure. Record the serial number, MAC address, and other information on the label for future use.
Page 9
English Note The wall bracket has side A and side B. Make sure side A faces the wall and determine the direction of the cable hole on the wall bracket based on the wiring direction. In this example, the cable hole faces upwards.
English Chapter 2 Cable Connection After completing the network configuration, use an Ethernet cable to connect a PC to the LAN port on the AP. The PC can access the network but cannot access the local Web management page.
English Chapter 3 LED Status Description Table 3-1 LED Status Description Status Description No power is present or the LED has been turned off from the CLI. The AP is initializing, or an initialization Steady on exception has occurred. Yellow Fast flashing All Ethernet ports are down.
Page 13
English Chapter 4 FAQ Scan the QR code below for more information.
Por favor, encuentre la versión más reciente de este Documento en la página web de Hikvision (https://www.hikvision.com). A menos que se convenga lo contrario, Hangzhou Hikvision Digital Technology Co., Ltd. o sus filiales (en lo sucesivo, "Hikvision") no ofrecen garantí as, expresas o implí citas.
Page 15
DOCUMENTACIÓ N, YA SEA POR INCUMPLIMIENTO DE CONTRATO, AGRAVIO (INCLUIDA LA NEGLIGENCIA), RESPONSABILIDAD POR EL PRODUCTO O DE OTRO TIPO, EN RELACIÓ N CON EL USO DEL PRODUCTO, INCLUSO SI HIKVISION HA SIDO ADVERTIDO DE LA POSIBILIDAD DE TALES DAÑ OS O PÉRDIDAS.
Español Modelos aplicables Este manual es aplicable al punto de acceso DS-3WAP521-SI. Convenciones de sí mbolos A continuación se definen los sí mbolos que puede encontrar en este documento. Sí mbolo Descripción Proporciona información adicional para remarcar o complementar Nota puntos importantes del texto principal.
Español Capítulo 1 Instalación del Dispositivo Nota Nunca coloque el dispositivo en un lugar inestable. El dispositivo podría caerse y provocar lesiones personales graves o la muerte. Instale equipos de protección de seguridad si es necesario. Revíselo periódicamente. Se recomienda instalar el dispositivo de acuerdo con las siguientes instrucciones. No somos responsables de ningún resultado proveniente de modificaciones o instalaciones arbitrarias individuales.
Page 18
Español Nota La lista de contenido varía según el dispositivo. Prevalece la lista de contenido real. Cualquier otro accesorio necesario durante la instalación, como el soporte de pared, debe obtenerlo usted mismo. Elemento Cantidad Punto de Acceso con Gestión Inteligente ×...
Page 19
Español Nota Puede suministrar energía al AP a través de PoE solo desde el puerto de enlace ascendente. No bloquee la parte frontal del AP a una distancia cercana durante su uso para evitar interferencias con la cobertura de la señal. , a continuación vuelva a instalar la cubierta del AP.
Page 21
Español Nota El soporte de pared tiene un lado A y un lado B. Asegúrese de que el lado A está orientado hacia la pared y determine la dirección del orificio del cable en el soporte de pared según la dirección del cableado.
Español Capítulo 2 Conexión de Cables Una vez completada la configuración de la red, utilice un cable Ethernet para conectar un PC al puerto LAN del AP. El PC puede acceder a la red pero no puede acceder a la página de administración web local.
Page 24
Español Capítulo 3 Descripción del Estado del LED Tabla 3-1 Descripción del Estado del LED Estado Descripción No hay energía o el LED se ha apagado Apagado desde la Interfaz de Línea de Comandos (CLI). El AP se está inicializando o se ha Encendido estable producido una excepción de inicialización.
NA MEDIDA MÁXIMA PERMITIDA PELA LEI APLICÁVEL, ESTE DOCUMENTO E O PRODUTO DESCRITO, COM O SEU HARDWARE, SOFTWARE E FIRMWARE, SÃO FORNECIDOS “TAL COMO ESTÃO” E “COM TODAS AS SUAS FALHAS E ERROS”. A HIKVISION EXCLUI, DE FORMA EXPLÍCITA OU IMPLÍ CITA, INCLUINDO E SEM LIMITAÇÃO, GARANTIAS DE COMERCIABILIDADE, QUALIDADE DO SERVIÇO OU ADEQUAÇÃO A UMA FINALIDADE ESPECÍ...
Page 27
DO CONTRATO, ATOS ILÍ CITOS (INCLUINDO NEGLIGÊNCIA), RESPONSABILIDADE PELO PRODUTO OU, DE OUTRO MODO, RELACIONADA COM A UTILIZAÇÃO DO PRODUTO, AINDA QUE A HIKVISION TENHA SIDO AVISADA SOBRE A POSSIBILIDADE DE TAIS DANOS OU PERDAS. O USUÁRIO RECONHECE QUE A NATUREZA DA INTERNET OFERECE RISCOS DE SEGURANÇA INERENTES E QUE A HIKVISION NÃO SERÁ...
Page 28
Português Modelos aplicáveis Este manual é aplicável ao ponto de acesso DS-3WAP521-SI. Convenções relativas aos sí mbolos Os sí mbolos presentes neste documento são definidos da seguinte maneira. Sí mbolo Descrição Proporciona informação adicional para enfatizar ou complementar Nota pontos importantes do texto principal.
Português Capítulo 1 Instalação do dispositivo Nota Nunca coloque o dispositivo em um local instável. O dispositivo pode cair e causar sérios ferimentos ou morte. Instale equipamentos de proteção de segurança, se necessário. Verifique regularmente. Recomendamos instalar o dispositivo de acordo com as instruções a seguir. Não nos responsabilizamos por quaisquer resultados decorrentes de modificações ou instalações arbitrárias individuais.
Page 30
Português Nota A lista da embalagem varia de acordo com o dispositivo. A lista da embalagem real prevalece. Quaisquer outros acessórios de instalação necessários durante a instalação, como o suporte de parede, devem ser preparados por você. Item Quantidade Ponto de acesso gerenciado com inteligência ×...
Page 31
Português Nota Você pode fornecer energia ao ponto de acesso apenas através da porta de uplink usando PoE. Não bloqueie a parte frontal do ponto de acesso nas proximidades durante o uso para evitar interferência na cobertura do sinal. e, em seguida, reinstale a tampa do ponto de acesso.
Page 33
Português Nota O suporte de parede tem um lado A e um lado B. Certifique-se de que o lado A esteja voltado para a parede e determine a direção do furo do cabo no suporte de parede com base na direção da fiação.
Page 35
Português Capítulo 2 Conexão de cabos Após concluir a configuração da rede, use um cabo Ethernet para conectar um PC à porta LAN do ponto de acesso. O PC pode acessar a rede, mas não pode acessar a página de gerenciamento da Web local.
Page 36
Português Capítulo 3 Descrição do status do LED Tabela 3-1 Descrição do status do LED Status Descrição Não há energia presente ou o LED foi Desligado desligado pela CLI. O ponto de acesso está sendo Acesa fixa inicializado ou ocorreu um erro de inicialização.
Português Capítulo 4 Perguntas Frequentes Escaneie o código QR abaixo para obter mais informações.
Page 38
Products described in this Document, which may include licenses obtained from third parties. Any part of the Document, including text, pictures, graphics, etc., belongs to Hikvision. No part of this Document may be excerpted, copied, translated, or modified in whole or in part by any means without written permission.
Page 39
Bahasa (INCLUDING NEGLIGENCE), PRODUCT LIABILITY, OR OTHERWISE, IN CONNECTION WITH THE USE OF THE PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES OR LOSS. YOU ACKNOWLEDGE THAT THE NATURE OF THE INTERNET PROVIDES FOR INHERENT...
Page 40
Bahasa Model yang Berlaku Manual ini berlaku untuk titik akses DS-3WAP521-SI. Konvensi Simbol Simbol-simbol yang mungkin ditemukan dalam dokumen ini didefinisikan sebagai berikut. Simbol Deskripsi Memberikan informasi tambahan untuk menekankan atau Catatan melengkapi poin penting dari teks utama. Menunjukkan situasi yang berpotensi membahayakan, yang jika tidak...
Page 41
Bahasa Bab 1 Instalasi Perangkat Catatan Jangan sekali-kali meletakkan perangkat di tempat yang tidak stabil. Perangkat dapat jatuh dan menyebabkan cedera serius atau kematian. Pasang peralatan perlindungan keselamatan jika perlu. Periksa secara berkala. Disarankan untuk memasang perangkat sesuai dengan petunjuk berikut. Kami tidak bertanggung jawab atas hasil apa pun yang timbul akibat modifikasi atau pemasangan yang sewenang-wenang.
Page 42
Bahasa Tabel 1-2 Daftar Kemasan Barang Kuantitas Smart Managed Access Point × 1 Paket Sekrup × 1 Panduan Cepat × 1 Informasi Kepatuhan Peraturan dan Keselamatan × 1 Lepaskan penutup AP, lalu lihat label perangkat seperti yang ditunjukkan pada gambar berikut. Catat nomor seri, alamat MAC, dan informasi lainnya pada label untuk penggunaan di masa mendatang.
Page 44
Bahasa Catatan Braket dinding memiliki sisi A dan sisi B. Pastikan sisi A menghadap ke dinding dan tentukan arah lubang kabel pada braket dinding berdasarkan arah kabel. Dalam contoh ini, lubang kabel menghadap ke atas.
Page 46
Bahasa Bab 2 Koneksi Kabel Setelah menyelesaikan konfigurasi jaringan, gunakan kabel Ethernet untuk menghubungkan PC ke port LAN pada AP. PC dapat mengakses jaringan tetapi tidak dapat mengakses halaman manajemen Web lokal.
Page 47
Bahasa Bab 3 Deskripsi Status LED Tabel 3-1 Deskripsi Status LED Status Deskripsi Tidak ada daya atau LED telah Mati dimatikan dari CLI. AP sedang diinisialisasi, atau tetap stabil pengecualian inisialisasi telah terjadi. Kuning Berkedip cepat Semua port Ethernet mati. (dua kali per detik) AP telah dimulai dan didaftarkan pada tetap stabil...
Page 48
Bahasa Bab 4 FAQ Pindai kode QR di bawah untuk informasi lebih lanjut.
Need help?
Do you have a question about the DS-3WAP521-SI and is the answer not in the manual?
Questions and answers