Storage; Shipping & Package List - First Co First-Pak AC FPE Series Installation, Operation And Maintenance Manual

STORAGE

Equipment should be stored in a clean dry, conditioned
area with maximum temperatures up to 120°F [48.89°C]
and minimum temperatures to 32°F [0°C]. Units should be
stored upright and in an indoor environment. It is
recommended to leave packaging on the unit until the
installation is to begin.
WARNING
DO NOT stack more than FOUR units for storage
purposes. Failure to follow these instructions may
result in
improper installation, adjustment, service or
maintenance, property damage, personal injury or
death.
The manufacture does not warrant equipment subjected to
abuse.
SHIPPING & PACKAGE LIST
NOTE
Material in this shipment has been inspected at the
factory and released to the transportation agency in
good condition. When received, a visual inspection of
all cartons should be made immediately. Any evidence
of rough handling or apparent damage should be
noted on the delivery receipt in the presence of the
carrier's representative. If damage is found, a claim
should be immediately filed against the carrier.
SHIPPING INSTRUCTIONS
The units must remain in the upright position throughout
the shipping and handling process to maintain a proper
level of oil in the compressor.
NOTE
Shrink-wrap is located around the unit for protection.
Remove before installation.
FPE SERIES – IOM (REV. E 3/24)
FIGURE 2 - Standard Packaging
PACKAGE LIST
The units will be shipped with the following items:
1- FPE (FIRST-PAK) package electric heat/dx cooling
unit:
A- Shipping bracket
a. Screws
B- Top mounting bracket
a. Screws
2- Literature package
A- IOM - Installation & Operations Manual
Check the unit for shipping damage; if found, immediately
contact the last carrier.
–
FIRST-PAK IOM
8