Safety Considerations - First Co First-Pak AC FPE Series Installation, Operation And Maintenance Manual

Vertical packaged electric heat / electric cooling unit
Table of Contents

Advertisement

SAFETY CONSIDERATIONS

1. READ THE ENTIRE MANUAL BEFORE STARTING THE INSTALLATION.
2. These instructions are intended as a general guide and DO NOT supersede national, state, or local codes in any way.
3. Altering the product, improper installation, or the use of unauthorized factory parts voids all warranty or implied warranty
and may result in adverse operation and/or performance or may result in hazardous conditions to service personnel and
occupants. Company employees or contractors are not authorized to waive this warning.
4. This product should only be installed and serviced by a qualified, licensed, and factory authorized installer or service agency.
5. All "kits" and "accessories" used must be factory authorized when modifying this product. Refer and follow instructions
packaged with the kits or accessories when installing.
RECOGNIZE THE FOLLOWING SAFETY NOTATIONS THROUGHOUT THIS MANUAL
DANGER
Indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING
Indicates a potentially hazardous situation or unsafe
practices that could result in severe personal injury or death
and/or damage to property.
WARNING
ELECTRIC SHOCK HAZARD
This warning signifies potential electrical shock hazards that
could result in personal injury or death.
CAUTION
Indicates a potentially hazardous situation that may result in
minor or moderate injury.
FPE SERIES – IOM (REV. E 3/24)
AND POSTED ON THE EQUIPMENT:
IMPORTANT
Suggests important procedure steps to insure proper
installation, reliability, or operation.
NOTE
Used to highlight suggestions, which may result in enhanced
installation, reliability or operation.
WARNING
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly could result in
dangerous operation, property damage , serious injury, or
death
Improper servicing could result in dangerous operation,
property damage, serious injury, or death.
 Before servicing, disconnect all electrical power to
the unit.
 When servicing controls, label all wires prior to
disconnecting. Reconnect wires correctly.
Verify proper operation after servicing.
FIRST-PAK
IOM
4

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the First-Pak AC FPE Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents