Powering On/Off The Projector; Powering On The Projector - Acer PH730 series User Manual

The lens cap must

be open then turn
on the projector.
Turn on the pro-

jector first and then
the signal sources.

Powering On/Off the Projector

Powering On the Projector

1. Open the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will flash amber.
3. Turn on the lamp by pressing "Power" button on the control
panel.  And the Power LED will turn solid amber.
4. Turn on your source (computer, notebook, video player
,etc.). The projector will detect your source automatically.
 If the screen displays "Lock" & "Source" icons, it means the pro-
jector locks on this source type and there is no such type of input
signal found.
If the screen displays "No Signal", please make sure the signal

cables are securely connected.
If you connect multiple sources at the same time, using the

"Source" button on the remote control or control panel to switch.
r
If the projection lens cap is not opened when a projector is powered
on, users will hear a continuous two-beep sound, and the interval of
each two-beep warning message is about 3 seconds.
r
The projector will not be turned on and automatically gone to a stand-
by mode if the lens cap is still closed after two-beep sound keeps
warning for 5 times.
r
If the projection lens cap is accidentally closed while the projector is
running, users will hear the same beep and the projector will auto-
matically go to a stand-by mode if the lens cap is still not opened after
5 times of warning message.
Introduction
Power
1

... English