Lpus; Lsq1Fp48Sa0 - 3Com S7906E Getting Started Manual

LED
FAIL
LPU status LEDs (SLOT0 through SLOT11)
SLOT0 through SLOT11: The LEDs indicate the status of the LPUs seated in the twelve slots.
Table 1-75 Description of the LPU status LEDs
LED
RUN
ALM
If the RUN LED flashes at a high frequency, the card is in the startup process, but is not yet operational.
At system startup, the ALM LED will be ON for a while, but it does not mean that the card is faulty.
ACTIVE LED
The ACTIVE LED shows the active/standby status of the LSQ1SR12GB0. If the ACTIVE LED is ON, the
LSQ1SR12GB0 is active; if OFF, the LSQ1SR12GB0 is standby.
RESET button
A reset button is provided on the LSQ1SR12GB0 for you to reset the card when necessary.

LPUs

LSQ1FP48SA0

Introduction
The LSQ1FP48SA0 provides forty-eight 100Base-FX-SFP ports.
Table 1-76 Technical specifications of the LSQ1FP48SA0
CPU
Boot ROM
DDR SDRAM
Dimensions (H x W x D)
Power consumption
Connector type
Number of ports
ON: The fans are faulty or out of position.
OFF: The fans operate normally.
ON/OFF: The LPU is faulty or out of position.
Blinking: The LPU is operating normally.
OFF: The LPU is operational or out of position.
ON: The LPU is faulty.
Item
MIPS64, 400 MHz
512 KB
512 MB
40 × 377 × 355 mm (1.57 × 14.84 × 13.98 in.)
34W to 85 W
LC
48
Description
Description
Specifications
1-42