Bits per second: 9600
Data bits: 8.
Parity: None
Stop bits:1
Flow control: None
Terminal emulation: VT100
The procedure is as follows:
Select Start > Programs/All Programs > Accessories > Communications > HyperTerminal to enter
the HyperTerminal window to establish a new connection and the system will pop up the Connection
Description dialog box.
Figure 4-2 Connection description of HyperTerminal
Type the name of the new connection and click OK. Then there pops up the interface as shown in the
following figure. Select the serial port to be used from Connect using drop-down list box.
Figure 4-3 Set serial port for HyperTerminal connection
4-2