Standard Beeper Definitions (Continued)
Table 2-1
Host Specific
USB only
4 short high beeps
Scanner gives a power-up beep after scanning a
USB Device Type.
This power-up beep occurs more than once.
RS-232 only
1 short high beep
LED Definitions
In addition to beeper sequences, the scanner communicates using a two-color LED display.
colors that display during scanning.
Standard LED Definitions
Table 2-2
LED
Off
Green
Red
Beeper Sequence
No power is applied to the scanner, or the scanner is on and ready to scan.
A bar code was successfully decoded.
A data transmission error or scanner malfunction occurred.
Indication
Scanner has not completed initialization. Wait several
seconds and scan again.
Communication with the bus must be established
before the scanner can operate at the highest power
level.
The USB bus may put the scanner in a state where
power to the scanner is cycled on and off more than
once. This is normal and usually happens when the
PC cold boots.
A <BEL> character is received and Beep on <BEL> is
enabled.
Indication
Scanning
2 - 3
Table 2-2
defines LED