Full Speed Usb Ms1690-40 (Integrated); Low Speed Usb Ms1690-38 (Integrated) - Metrologic MS1690 - Focus - Wired Handheld Barcode Scanner Installation And User Manual

I
NSTALLING THE
Integrated USB:
Full Speed MS1690-40
Low Speed MS1690-38
1. Turn off the host device.
2. Plug the male 10-pin RJ45 end of the
USB cable into the 10-pin socket on
the Focus. You will hear a 'click' when
the connection is made.
3. Plug the USB type A end of the USB
cable into the host's USB port.
4. Turn on the host device.
5. Focus will start to initialize. All LEDs
(yellow, white, and blue) will light for
approximately 2 seconds then start to
alternately flash. When the scanner
has finished initializing the LEDs will
stop flashing and the unit will beep
3 times indicating that the scanner is
ready for use.
As a default, the MS1690-38 leaves the factory with USB Keyboard
Emulation Mode eabled.
For information on configuring the MS1690-38 for USB Serial Emulation
Mode, please refer to the USB section of the MetroSelect Single-Line
Configuration Guide (
Plugging the scanner into a port on the host device does not guarantee
that scanned information will be communicated properly to the host
device. The scanner is shipped from the factory configured with default
settings. Please refer to the MetroSelect Single-Line Configuration
Guide (
MLPN
changing the scanner's configuration. In addition, please check that the
scanner and host system are using the same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.
S
CANNER TO THE
00-02544).
MLPN
00-02544) or MetroSet2's help files for instructions on
H S
OST YSTEM
Figure 10.
11