Using An External Demodulator; How To Install The Software Modules - Wavecom W 4010 User Manual

1.7 CONFIGURING THE BAUD RATE
AND DATA
SERIAL COMMINICATION
Choose module
module key while
monitor. Thereafter
obtain the menu
communication parameters.
key allows configuring
rate to either
2400, 4800, or 9600 Baud
The number of data and stop bits
can be adjusted with F2 to either 7
In order to transfer the data's of
the serial interface,
necessary to
Program in a PC. With the terminal
Program you can save the data's on
a disk.
1.8 USING AN EXTERNAL
DEMODULATOR
In order to connect
demodulator you must first open the
case. Locate jumper #3 and change
it from the
(internal demodulator)
right-hand position (seen from the
f r o n t p a n e l ) .
demodulator can now be connected to
the 5-pole DIN rear panel jack. The
external demodulator input can be
driven with either TTL or RS-232
DIP switch pole
FORMAT FOR
A by pushing
watching
push F2
to setup
The
the Baud
300, 600, 1200,
it
load a terminal
an external
left-hand position
to
T h e e x t e r n a l
1 2 3
ON OFF OFF OFF 1 module inserted
OFF ON OFF OFF 2 modules inserted
OFF OFF ON
OFF OFF OFF ON
data bits
bits / 2 stop bits, 8 data bits / 1
stop bit,
bits.
the
The parity
the
help of F3 to NO, ODD, or EVEN.
to
the
The programmed values are stored in
F1
a non-volatile
stored even without power. By means
of F1, F2, and F3 the operator can
easily configure
decoder to communicate with any RS-
232 equipment.
level signals.
is
1.9 HOW TO INSTALL THE SOFT-
WARE MODULES
Before undertaking any changes in
the equipment make sure the power
is disconnected.
The EPROM
easily seen indentation on one end.
When inserting
indentation must point to the front
of the equipment. Also the EPROM
the markings should be oriented similar
to that of EPROM A. The EPROM has
to be inserted in the proper sense,
otherwise
destroyed!
Set the DIP switch, located behind
module C, as follows:
4
OFF 3 modules inserted
4 modules inserted
/ 1 stop bit,
8 data bits /
can be adjusted
memory and
the
memory chips have
the EPROM,
it probably will
Page 4
7 data
2 stop
with
stay
WAVECOM
an
this
be