Table of Contents
Advertisement
10/100 Auto Negotiation Switch User's Guide
Create New Trunking Port
The Create New Trunking Port panel, displayed in Figure 32, is used to create Trunk Ports.
You can create up to seven trunking groups with up to eight ports in each group. Each
Trunking Group acts like a single port.
Figure 32: Create New Trunking Port
New Trunking Group Name
Is the name of the Tunking Group you are going to create. All Trunking Groups must have a
name.
Port #
Is the number of the port. The numbers on the panel match the ports on the DES-3224. Some
ports are not available for trunking. For example, port 3 has a status of N/A . Ports that are
shown as N/A are not available for inclusion in any trunking groups.
Name
This field identifies the TrunkGroup that the port has been assigned to. The field is open if
the port has not been assigned to a TrunkGroup.
Status
The status field can be either available or selected. Available indicates that the port is
available for inclusion in a TrunkGroup. Selected indicates the port has been assigned to a
54
Managing the DES-3224
Advertisement
Table of Contents
