Managing The Des-3224; Local Console Management - D-Link DES-3224 User Manual

D-link systems 10/100 auto negotiation switch user's guide des-3224

Hide thumbs Also See for DES-3224:

Frequently asked questions (4 pages)

Table Of Contents

Table of Contents

10/100 Auto Negotiation Switch User's Guide

This chapter shows the menus used to manage the DES-3224.

Three types of management are available on the DES-3224:

Local Console Management (out-of-band)

Telnet Management (in-band)

D-View/ SNMP Management

The DES-3224 can be managed in-band or out-of-band. In-band management refers to

managing the DES-3224 through the MDI-II uplink port or any of the MDI-X ports. Out-of-

band management means going through the RS-232 port.

The interface and options are the same with Local Console and Telnet Management. The

difference is the type of connection and the port that is used to manage the DES-3224.

D-View is a proprietary SNMP management program. D-View is provided with the DES-

3224. The DES-3224 supports other SNMP management applications and uses standard

MIB. Refer to appropriate documentation for installing and using other SNMP application

programs. The look and feel of D-View is different from other management types. Refer to

other documentation if you are using other vendors' SNMP applications.

All instructions given in this chapter assume that you are logged into the DES-3224 and are

at the appropriate panel for carrying them out.

Local Console Management

Local Console Management is always done through the RS-232 Serial port and requires a

direct connection between the DES-3224 and a PC. This type of management is very useful

when the network is down and the DES-3224 cannot be reached by any other means.

Use Local Console Management to log into the DES-3224 for the first time. You do not need

to know the IP address to log into the DES-3224 using Local Console Management. You can

change all the settings and configure the DES-3224, set the IP address and perform other

management functions.

Follow these steps to begin a management session using Local Console Management:

1. Attach the male end of the RS-232 serial cable provided with the DES-3224 to the RS-

232 port located at the rear of the DES-3224.

2. Attach the other end to the serial port of a PC or workstation.

3. Run a terminal emulation program using the following settings:

Emulation: VT-100/ANSI compatible

BPS: 19 200

Data bits: 8