Lumascape LS9050 Installation Instructions

Lumascape
Brisbane Technology Park
18 Brandl Street, Eight Mile Plains, QLD 4113, Australia
PO Box 4059, Eight Mile Plains, QLD 4113, Australia
T +61 7 3854 5000
F +61 7 3854 5001
E sales@lumascape.com.au
W www.lumascape.com.au
LS9050
Warranty void if not installed as per installation instructions
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
Luminaire Input
Connect with:
- Leader cable
- Jumper cable
- Other luminaire in chain
Vertical Mounting Surface
www.lumascape.com.au
Tilt Lock
Using the Allen key provided, lock
tilt by tightening the 2 locking
screws, accessed via the ports
on the bracket
Allen Key
Use Allen key (supplied) to
tighten mounting bracket onto
luminaire
Bracket Mounting Orientations
Horizontal Mounting Surface
INSTALLATION INSTRUCTIONS
Luminaire Loop-Through
Use to connect to next
luminaire or use termination
connector if no other
luminaire follows in series.
For last luminaire in the
circuit, replace endcap with
PowerSync
(LS6405-supplied with leader
cable)
Mounting Bracket
Use mounting brackets (supplied) to affix
luminaire to a suitable mounting surface.
Use maximum 1/4" (6.5mm) fasteners of
type suitable for substrate - DO NOT USE
COUNTERSUNK FASTENERS.
MODEL LS9050
SUPPLY VOLTAGE 120-277 V, 50/60 Hz
terminator
TM
IN0170 170511 - 11 May 2017
FACADE
N653