Polypipe UFHBOOSTWP User Manual page 6

User's manual
V. How to register the room thermostat in a
particular zone
Each room thermostat should be registered in one zone. Enter UFH8ZMP wiring Centre
menu and select Sensor in the submenu of a given zone (Zone/Registration/Sensor). Select
Registration and press communication button on UFHBOOSTWP temperature thermostat.
If the registration process has been completed successfully, the UFH8ZMP display
shows an appropriate message whereas the room thermostat display shows "Scs". In case
of errors in the registration process, the room thermostat display shows "Err".
NOTE
Only one room thermostat may be assigned to each zone.
The following rules must be kept in mind:
- once registered, the sensor cannot be unregistered, but only switched off in the menu
of UFH8ZMP external controller by selecting Switched off in the submenu of a given zone,
- if the user attempts to assign a sensor to the zone to which other sensor has already
been assigned, the fi rst sensor becomes unregistered and it is replaced by the second one.
- if the user attempts to assign a sensor which has already been assigned to a diff erent
zone, the sensor is unregistered from the fi rst zone and registered in the new one.
It is possible to set individual pre-set temperature value and weekly schedule for each
room sensor assigned to a given zone. The settings may be confi gured both in UFH8ZMP
wiring Centre menu (Main menu/Sensors) and via polypipe.emodul.eu (using Internet
module). Using PLUS and MINUS buttons the user may adjust the pre-set temperature
directly from the room sensor.
Communication
button
6