Field Of Application; Transport And Handling; Before Initial Operation; Initial Operation - Seto LED SNAKE EASY Instructions For Use Manual

SETO LED SNAKE EASY rope lights are applicable as outdoor and indoor lighting / pathway lighting for industry, crafts,
workshops, tents, rescue services, energy suppliers, railway and transport companies etc. SETO LED SNAKE EASY rope
lights are developed to offer you optimal illumination directly at the workplace.
Operation in a potentially explosive environment is not permitted.
For transport and storage, use the plastic reel with drum permanently integrated into the rope light and roll up the rope
light in it.
ATTENTION!
Check the product for damage before each use! This way you will considerably reduce the risk of accidents.
In principle, the SETO LED SNAKE EASY is delivered ready for connection with a supply cable and plug. The rope light is
only to be connected to an alternating current – with the voltage according to the rating plate – to a properly installed
safety socket. Please note that your system corresponds to the relevant VDE guidelines.
If you have any questions about this, please contact your energy supplier or your electrician. Of course we are at your
disposal if you have any questions.
Electric connection
Connect the mains plug of the connecting cable to your mains connection socket.
The rope light is ready for operation once it has been connected to the mains power supply.
DANGER! Electric current!
• This product may present a potential electric shock or fire hazard if improperly installed or fastened in any way.
SETO LED SNAKE EASY series rope lights should be installed in accordance with this manual, current
electrical codes and / or the current National Electric Code (NEC).
• Maintenance or repair work can only be carried out on the supply line of the rope light and may only be carried
out by qualified electricians. The relevant safety regulations for working on electrical systems apply.
Before any maintenance, repair or cleaning, the unit must always be disconnected from the mains supply
by pulling out the mains plug.
1. Pull the entire LED strip out of the reel.
2. Make sure that you have pulled the entire LED strip out of the reel before connecting the power.
3. After use: Turn the handle clockwise until the entire LED strip is back on the roll.

Field of application

Transport and handling

Before initial operation

Initial operation

9