Nova 8220 How To Install

HOW TO
INSTALL YOUR
Tub Grab Bar
Item # 8220/8220-R
Capacity not to exceed 250 lb
1
Loosen the clamp by turning the three-pronged knob counterclockwise and remove the
styrofoam block from between the clamp.
2
Adjust clamp opening to fit over the side of the bathtub (Figure A). Set the Tub Grab Bar to
the location that most conveniently assists the user to enter and exit the bathtub. Tighten knob
clockwise until the Tub Grab Bar is securely clamped onto the side of the bathtub (Figure B).
3
Pull on the Tub Grab Bar to make sure it is secure on the bathtub.
HOW TO USE
Hold on to the Tub Grab Bar when entering and exiting the bathtub. Use the Tub Grab Bar
for balance when needed.
CARE AND MAINTENANCE
Check regularly to make sure the Tub Grab Bar is securely clamped to the bathtub. Use a
mild detergent and warm water to clean.
CAUTION
Do NOT overtighten on fiberglass bathtubs. Doing so may cause bathtub to crack or break,
resulting in injury or fall.
Figure A Figure B
No tools required
Quick Assembly
Easy to follow
step-by-step
instructions