Connecting Programmer To Vp200 - Apollo VP200 Programming Manual

VP200

Connecting Programmer to VP200

Refer to Figure then connect the programmer kit as follows:
1. At the rear of the PC, connect the USB cable Type A Male to the USB port.
2. Plug the USB cable Type B Male into USB connector of the VP200 programmer.
Hardware installation is complete.
Computer
VP 200
VP 200
Programmer
Figure Programmer Hardware Connections Figure Programmer Hardware Connections
Figure Programmer Hardware Connections Figure Programmer Hardware Connections
March 12, 2007
PAGER PROGRAMMING SOFTWARE
Connecting Programmer to VP200
USB Cable Type
A to B
8